Prity WD W29

Prity WD W29 Wood Boiler Stove 29+8KW User Manual

Modelis: WD W29 | Zīmols: Prity

1. Ievads

This user manual provides essential information for the safe and efficient installation, operation, and maintenance of your Prity WD W29 wood boiler stove. Please read these instructions carefully before using the appliance and retain them for future reference. This stove is designed for residential premises using solid fuel, wood briquettes, or dry wood.

2. Drošības informācija

Always prioritize safety when operating any wood-burning appliance. Failure to follow these safety guidelines can result in property damage, injury, or death.

2.1. Vispārīgi drošības pasākumi

2.2 Clearances to Combustible Materials

Maintain the following minimum distances from combustible materials to prevent fire hazards:

Note: These distances are minimum requirements. Always consult local building codes and regulations, which may require greater clearances.

Prity WD W29 wood boiler stove, front view with cream side panels.

1. attēls. Priekšpuse view of the Prity WD W29 wood boiler stove. This image shows the main structure, including the combustion chamber door and ash pan.

3. Iestatīšana un instalēšana

Installation of this appliance must be performed by a qualified professional in accordance with all local and national building and fire codes.

3.1. Izsaiņošana un pārbaude

3.2 Location and Hearth Requirements

3.3 Dūmvadu savienojums

Prity WD W29 wood boiler stove, side view showing the flue connection point.

2. attēls: sāni view of the Prity WD W29 stove, illustrating the flue pipe connection point at the top rear of the unit.

4. Lietošanas instrukcijas

Follow these steps for safe and efficient operation of your wood boiler stove.

4.1 Degvielas veids

Only use dry, seasoned wood or approved wood briquettes. The moisture content of wood should be below 20% for optimal efficiency and reduced emissions. Burning wet wood leads to creosote buildup and reduced heat output.

4.2 Ugunsgrēka iekuršana

  1. Open all air inlets (primary and secondary air controls) fully.
  2. Place crumpled newspaper or firelighters at the bottom of the combustion chamber.
  3. Stack small pieces of kindling on top of the newspaper/firelighters.
  4. Place a few small logs on top of the kindling.
  5. Ignite the newspaper/firelighters.
  6. Close the combustion chamber door once the kindling is burning steadily.
  7. Allow the fire to establish for 10-15 minutes with air controls fully open.
Prity WD W29 wood boiler stove with the top combustion chamber door open.

Figure 3: The Prity WD W29 stove with its upper door open, revealing the large combustion chamber for fuel loading.

4.3 Adding Fuel and Air Control

  1. Before opening the combustion chamber door, open the air controls fully for a few moments to prevent smoke spillage.
  2. Carefully open the door and add more logs as needed.
  3. Close the door and adjust the air controls to achieve the desired burn rate and heat output. Reduce primary air for a slower burn, and secondary air for cleaner combustion.

5. Apkope

Regular maintenance ensures the longevity and efficient operation of your stove.

5.1. Pelnu noņemšana

Prity WD W29 wood boiler stove with the bottom ash pan door open.

Figure 4: The Prity WD W29 stove with its lower door open, providing access to the ash pan for easy cleaning.

5.2 Cleaning the Combustion Chamber and Flue

5.3 Vispārējā pārbaude

6. Traucējummeklēšana

This section addresses common issues you might encounter with your wood boiler stove.

ProblēmaIespējamais cēlonisRisinājums
Smoke entering the roomPoor chimney draft, blocked flue, door opened too quickly, wet wood.Check chimney for blockages. Ensure air controls are open before opening door. Use dry wood. Consult a chimney sweep.
Zema siltuma jaudaWet wood, insufficient air supply, small fire, creosote buildup.Use dry wood. Open air controls. Build a larger fire. Clean flue and stove.
Excessive burn rateToo much air, door seal leakage.Close air controls. Inspect and replace door seals if necessary.
Stikls ātri kļūst melnsWet wood, insufficient secondary air, low burning temperature.Use dry wood. Ensure secondary air is open. Maintain a hotter fire.

7. Tehniskās specifikācijas

The following specifications are based on the Declaration of Performance (EN 13240:2001/A2:2007).

FunkcijaVērtība
ModelisPrity WD W29, WDW29D
Paredzētā lietošanaFree-standing fireplace for residential premises using solid fuel / wood briquettes or dry wood
RažotājsPrity 95 Ltd., 33, M. Raykovich str., 5140 Lyaskovets, Bulgaria
Harmonizētais standartsEN 13240:2001/A2:2007
Kopējie izmēri (P x Dz x A)650 x 550 x 1150 mm
Combustion Chamber Dimensions (W x D x H)475 x 450 x 300 mm
Dūmvada caurules diametrsØ 150 mm
Nominal Heat Output (Total)31.5 kW
Room Heating Output9.4 kW
Water Heating Output22.1 kW
Ūdens sildītāja tilpums44 litri
Apsildāmās virsmas laukumsApm. 210 m²
Apkures jaudaAptuveni 569 m³
Energy Efficiency at Nominal Heat Output77.8 %
Sezonas efektivitāte68.8 %
Maximum Working Pressure (Water)1.25 bāri
Flue Gas Temperature at Nominal Heat Output222.0 °C
CO Emission (13% O2, dry wood)1237.5 mg/Nm³ (0.0990 %)
Dust Emission (13% O2, dry wood)30.9 mg/Nm³
OGC Emission (13% O2, dry wood)58.8 mg/Nm³
NOx Emission (13% O2, dry wood)145.0 mg/Nm³
MateriālsNerūsējošais tērauds
KrāsaMelns
Nepieciešama montāža
Degvielas veidsKoksne
Montāžas veidsBrīvi stāvoši
Image representing the Declaration of Performance for Prity WDW29 wood boiler stove, detailing technical specifications and compliance with EN 13240.

Figure 5: This image represents the Declaration of Performance document for the Prity WDW29, outlining key technical specifications and compliance standards. Please refer to the actual document for full details.

8. Garantija un atbalsts

For warranty information, technical support, or spare parts availability, please contact your retailer or the manufacturer directly.

Please have your model number (WD W29) and ASIN (B09VL73BVS) ready when contacting support.